Power By 24 Vac/36 Vdc; Recommendations For 24 Vac Power Supply - Bosch AUTODOME 7100i Installation Manual

AUTODOME 7100i│AUTODOME 7100i IR
10.3

Power by 24 VAC/36 VDC

10.3.1

Recommendations for 24 VAC Power Supply

Bosch recommends operating the AUTODOME 7100i IR camera models (NDP‑7602‑Z40L,
NDP-7604-Z12L) by IEEE 802.3bt PoE Type 4, 90W. You can also use a third-party 24 VAC,
50/60Hz power supply that meets the stated requirements.
A 24 VAC, 50/60Hz power supply must meet the following requirements to be used with the
AUTODOME camera.
The power supply must provide 24 VAC +/-10% voltage at the camera after any voltage drop
across the cable, and for the following current and power loads as in the table that follows.
2MP (non-
2MP IR, 4K
Warning!
The product should be supplied only by an external power supply that is a certified Class 2
!
or Limited Power Source (LPS) supply.
It must be an electrically Earth-grounded metal box with a watertight, electrically grounded
metal conduit that is connected between the box and the AUTODOME camera.
Note: For the system of the AUTODOME camera and the chosen power device (third-party
IEEE 802.3bt midspan or 24 VAC) to meet all of the AUTODOME certifications and
specifications, the midspan/power supply must meet the same certifications and
requirements.
Bosch Security Systems
Model Minimum current output required
24 VAC,
50/60 Hz
3
IR)
3.5
IR
(Amps)
PoE 54 36 VDC
VDC
0.9 1.3
1.2 1.85
Installation Manual
Connection | en
Minimum power output required
(Watts)
24 VAC, PoE 54
50/60 Hz VDC
(PF = 0.6)
43.2 48.6
53 64.8
2023-09-29 | V06 | F.01U.410.315
49
36 VDC
46.8
66.6