Table of Contents
Advertisement
32
en | Installing a pendant arm mount
Notice!
The following type of CAT 5E, CAT 6 or better Ethernet cable should be used:
i
F/UTP overall screened cable with unscreened twisted pairs (often referred to as FTP),
S/UTP overall braided shield with unscreened twisted pairs (often referred to as STP),
or with better shielding, and that meets the minimum bend radius of 30mm, and maximum
diameter of 0.24"(6mm).
3.
4.
5.
6.
7.
Notice!
i
Hotplugging is not allowed for SFP fiber module. Power must be removed from the camera
before plugging in an SFP module.
2023-09-29 | V06 | F.01U.410.315
If you do not install fiber, skip to step 16.
To install fiber, complete the next steps.
Remove the three (3) screws from the top cap to access the fiber connection.
Pull the top cap off the mount.
Install the SFP module into the fiber port on the top of the mount. Push the SFP
module into the port until you hear the catch engage.
Note: Ethernet communication is disabled when an SFP module is plugged into a fiber
mount (NDA-7100-PENF, or NDA-7100-PIPEF).
Connect fiber optic cable to the SFP module.
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
NDA-7100-PIPEF
NDA-7100-PENF
Bosch Security Systems
Advertisement
Table of Contents
