Table of Contents
Advertisement
62
en | Connection
1
2
3
Warning!
If reusing a VG4-A-PSU0, VG4-A-PSU1 and VG4-A-PSU2 from an earlier Bosch AUTODOME
!
camera, the cable wiring will need to be redone as shown and should not be plugged into
connectors P106 and P105 of the Power Supply Unit.
2023-09-29 | V06 | F.01U.410.315
Ground screw
P101 Connector; Power In (120 VAC /
230 VAC, 50/60 Hz) to a high voltage
side conduit hole 3/4 in. (20mm) NPS
fitting to electrically grounded metal
conduit to the power source.
Ground wire connects to external Earth
Ground and Power In; 3/4 in. (20mm)
NPS Fitting to electrically grounded
metal conduit
Note: The cable should remain on the
high voltage side of the metal divide
that separates high voltage from low
voltage in the power supply.
4
5
6
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
(Optional Pass-through) Audio input+/-,
Audio Output+/-, Alarm IN 1, Alarm IN
2, Relay NO, Relay NC, Relay COM,
DGND to a low voltage; 1/2 in. (15 mm)
NPS Fitting
Note: Audio and alarm I/Os pass
through the power supply box.as it
connects from the camera to the alarm,
audio test equipment which should be
placed in an IP66 rated grounded metal
box. Ground wire connection for the
camera is the screw terminal above
number 4.
P107 Connector; 24 VAC (pins 4, 5) and
ground (pin 3) to a conduit hole 3/4 in.
(20mm), or 1/2 in. (15mm) NPS fitting
to electrically grounded metal conduit
to the camera through its mount.
Note: Must use P107 pins 4, 5 for
24VAC power since that uses the 3.15 A
fuse in the power supply.
Ethernet cable from Camera through a
conduit hole 3/4 in. (20mm), or 1/2 in.
(15mm) NPS Fitting to electrically
grounded metal conduit
Note: The Ethernet cable passes
through the Power Supply box as it
connects from the camera to the test
PC
Bosch Security Systems
Advertisement
Table of Contents
