Bosch AUTODOME 7100i Installation Manual page 27

AUTODOME 7100i│AUTODOME 7100i IR
To Connect the AUTODOME 7100i Non-IR NDP-7602-Z40 to the Wall arm and 24VAC PSU
Kits (NDA-7100-PA0(F), NDA-7100-PA1(F) and NDA-7100-PA(F):
1.
2.
3.
Danger!
For the power supply models with 120VAC or 230VAC transformers (VG4-A-PSU1, VG4-A-
PSU2, NDA-U-PSU1 and NDA-U-PSU2): Route only 120VAC / 230VAC wiring and Earth
ground through the conduit holes in the high-voltage section of the power supply. Do not
route any other wires through the high-voltage section of the power supply.
Notice!
i
Both Hinge Pins must be fully compressed to open (unlock) the hinges of the Pendant Arm
and before proceeding to the next step.
4.
5.
6.
Bosch Security Systems
Connect the PSU to the back of the pendant wall arm, as in the figure that follows.
Note: Use liquid-tight, electrically grounded conduit in order to maintain the IP66
rating, and so that the metal conduit is connected electrically to the power supply box.
The bottom hinge pin of the Pendant wall arm is provided with a Hinge Pin Stop to hold
the hinge open while attaching the wall arm to the power supply box. Compress the
bottom hinge pin by pushing the pin lever downward and rotating it behind the Hinge
Pin Stop.
Open the top hinge by pushing its pin level up and holding it.
While continuing to hold the top hinge pin open, align the top and bottom hinges of the
Pendant Arm to their mating points on the Power Supply Box. See graphic.
Once the hinges are aligned, release the top hing pin to engage its mating hinge on the
power box.
Release the bottom hinge pin from the Hinge Pin Stop to lock the Pendant Arm to the
Power Supply Box.
Installation Manual
Installing a pendant arm mount | en
2023-09-29 | V06 | F.01U.410.315
27