Table of Contents
Advertisement
38
en | Installing a pipe mount
3.
–
–
2023-09-29 | V06 | F.01U.410.315
Make the appropriate connections for PoE (only if not using fiber), 24VAC ±
10%/36VDC ± 10%, alarms, and audio. If you connect fiber to the camera, then connect
only 24VAC/36VDC power input to the camera. Do not connect PoE.
Note: Add a tie wrap between the Ethernet cable and 24VAC/36VDC wires to prevent
the black plastic hook from pressing on the sun shield.
For audio and/or alarm inputs/outputs (I/O):
On the mount on the camera side, connect the drain wire of the Belden cable (or
similar cable) to chassis ground and grounded metal box.
Connect the other end of the drain wire to a grounded metal box that supports
electrically grounded conduit.
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
