Table of Contents
Advertisement
66
en | Connection
11. To electrically connect the arm or pipe mount and the camera housing to the power
12. (Optional step) Connect audio I/O and, or alarm inputs or alarm relay output from the
Refer to
–
2023-09-29 | V06 | F.01U.410.315
g. To the computer.
Note: Use proper grommets to guarantee an IP66 rating.
Note: Refer to Tools Required, page 14 for a list of the appropriate types of Ethernet
cable to use.
supply housing, connect the ground wire attached to the arm mount or pipe mount
from the camera to the metal spade, as shown in number 4 of the figure , page 61 in
this subchapter.
AUTODOME 7100i User Interface connections in one conduit hole and out the other,
through one of the two conduit holes in the PSU box, into a ¾" (20mm) or a ½"
(15mm) NPS metal conduit fitting, through metal conduit, to a metal box that will hold
this equipment. Refer to "Connecting the Alarm Inputs and Alarm Relay Output" and
"Connecting the Audio Input and Output Wires" for additional requirements.
Recommendations for 24 VAC Power Supply, page 49
X104
X105
X106
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
