Installing A Pipe Mount And Camera; Tools Required; Preparing The Ceiling For Installation; Installing The Pipe Mount - Bosch NDP-5512-Z30 Installation Manual

AUTODOME IP starlight 5000i
9

Installing a Pipe Mount and Camera

Notice!
Indoor use only!
This mount shall only be installed indoors. No outdoors installation is permitted.
9.1

Tools Required

–
–
–
9.2

Preparing the Ceiling for Installation

1.
Caution!
Select a rigid mounting location to prevent excessive vibration to the camera.
!
Notice!
The fasteners and mounting surface must be capable of supporting a maximum load of 11.33
kg (25 pounds).
2.
3.
4.
5.
9.3

Installing the Pipe Mount

1.
2.
Ensure that the cables are long enough to reach through the mount and the camera's
mounting cap to the connections from the camera.
1.
2.
3.
4.
5.
Bosch Security Systems
Appropriate tool for cutting a hole in drywall
No. 2 Phillips screwdriver
Torx screwdriver, T-25
Determine a secure location for the pipe mount. Ensure there is an adequate opening in
the ceiling or mounting structure for the cables to pass through.
Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
Drill the holes for the mounting screws.
Drill a hole (maximum of 20 mm [.79 in.]) in the center of the mounting location to feed
the cables through the mount.
Insert the wall anchors (user-supplied), if necessary, into the ceiling at the locations
marked in step 2.
Attach the direct connect plate to the ceiling or mounting surface.
Thread the RJ45 cable and 24 VAC cables through the ceiling and then through the
(adapter).
Attach the mounting flange and (adapter) to the direct connect plate using four M5
screws.
Thread the cables through the pipe mount.
Attach the pipe mount to the mounting flange and (adapter).
If you choose to install the pipe mount extension, thread the cables through the
extension. Attach the pipe extension to the open end of the pipe mount.
Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
Installation Manual
Installing a Pipe Mount and Camera | en 21
2018.05 | 1.0.3 |