Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
Notice!
Bosch recommends the use of surge/lightning suppression devices (sourced locally) to
i
protect network and power cables and the camera installation site. Refer to NFPA 780,
Class 1 & 2, UL96A, or the equivalent code appropriate for your country/region, and to local
building codes. Refer also to the installation instructions of each device (midspan, camera,
and surge suppression device installed where the cable enters the building).
Notice!
Always use one of the following types of shielded network connection cable and a shielded
RJ45 network cable connector: F/UTP overall screened cable with unscreened twisted pairs
(often referred to as FTP), S/UTP overall braided shield with unscreened twisted pairs
i
(often referred to as STP), or with better shielding, and that meets the minimum bend
radius of 30mm, and maximum diameter of 6mm.
Always use shielded cables/connectors in demanding indoor electrical environments where
the network cable is located in parallel with electrical mains supply cables, or where large
inductive loads such as motors or contactors are near the camera or its cable.
Notice!
Ancillary power (UPS) required
To meet the Mains Supply Voltage Dips and Short Interruptions requirements per EN
i
50130-4 Alarm Standard, ancillary equipment (for example, an Uninterruptible Power
Supply (UPS)) is necessary. The UPS must have a Transfer time between 2-6 ms and
Backup Runtime of greater than 5 seconds for the power level as specified on the product
data sheet.
Warning!
THE CAMERA MUST BE MOUNTED DIRECTLY AND PERMANENTLY TO A NON-COMBUSTIBLE
!
SURFACE.
–
–
Notice!
Risk of water ingress
If you:
i
- remove a camera from its mount but do not replace it promptly, or
- install the mount but do not install the camera immediately,
then you must remove the PCB from the mount to avoid moisture or water ingress and
potential corrosion.
Notice!
i
Before adding or removing an SD card from the camera, disconnect all power sources
(including POE) from the device.
Bosch Security Systems
Make sure that the installation conditions comply with the specified stresses of
vibration and shock as mentioned in the datasheet.
Use on mobile platforms is not recommended. Refer to the warranty statement for more
information.
Installation Manual
Safety | en
2023-09-29 | V06 | F.01U.410.315
7
Advertisement
Table of Contents
