Daikin EBLA04E V Series Service Manual page 221

To install the thermistor
EBLA04~08E + EDLA04~08E
Daikin Altherma 3 M
ESIE22-09 – 2022.05
INFORMATION
Some of the thermistors are wired to the same connector. See connector and pin
information of the thermistors at the start of the electrical check procedure and
"7.2 Wiring diagram" [
to the same connector.
4 When removing the complete set of thermistors wired to the same connector:
▪ Remove all other thermistors wired to the connector from their thermistor
holder,
▪ Disconnect the thermistor connector,
▪ Remove the complete set of thermistors.
5 To install the thermistor, see
1 Install the thermistor as follows:
▪ For air (ambient) thermistor:
Insert the thermistor in the protection tube.
Correctly install the thermistor in the heat exchanger grille recess.
▪ For refrigerant piping thermistors:
Pull the clip and install the thermistor in the specific thermistor holder. Make
sure the clip is in the correct position (blocking the thermistor).
c
a
4
281]. ALWAYS replace the complete set of thermistors wired
"Repair procedures" [
b
draft – 31/05/2022 15:53
4 | Components
4
219].
Service manual
221