Daikin EBLA04E V Series Service Manual page 155

EBLA04~08E + EDLA04~08E
Daikin Altherma 3 M
ESIE22-09 – 2022.05
a
a Compressor pipe
7 Stop the nitrogen supply when the piping has cooled down.
INFORMATION
It is ALSO possible to cut the component pipe(s) using a pipe cutter. Make sure to
remove the remaining component pipe end(s) from the refrigerant pipes by heating
the brazing point(s) of the component pipe(s) using an oxygen acetylene torch.
8 Remove the nuts and bolts and remove the compressor from the unit.
a
c
a
a Nut
b Compressor
c Damper
9 Remove the 3 dampers and springs from the compressor.
INFORMATION
The compressor dampers may look different.
10 Remove the bushings and keep them for re-use.
11 Install plugs or caps on the open pipe ends of the refrigerant piping to avoid
dirt or impurities from entering the piping.
12 To install the compressor, see
b
c
"4.7.2 Repair procedures" [
draft – 31/05/2022 15:53
4 | Components
a
a
c
4
153].
Service manual
155