Daikin EBLA04E V Series Service Manual page 200

4 | Components
To remove the DC fan motor assembly
To install the DC fan motor assembly
Service manual
200
draft – 31/05/2022 15:53
INFORMATION
Use a pulley remover if the propeller cannot be removed manually.
4 To install the propeller fan blade assembly, see
4
procedures" [ 199].
1 Remove the propeller fan blade assembly from the DC fan motor assembly,
see "4.15.2 Repair procedures" [
DANGER: RISK OF ELECTROCUTION
Confirm the rectifier voltage is below 10 V DC before proceeding, see
electrical hazards" [
2 Disconnect the DC fan motor connector from the main PCB.
e f e
a DC fan motor connector
b DC fan motor harness
c Tie strap
d Switch box
e Screw
f DC fan motor assy
3 Unlock the ferrite bead (if applicable).
4 Cut the tie strap.
5 Detach the DC fan motor harness from the switch box.
6 Slightly bend the harness retainers to detach the DC fan motor harness.
7 Remove the 4 screws that fix the DC fan motor assembly.
8 Remove the DC fan motor assembly from the unit.
9 To install the DC fan motor assembly, see
1 Install the DC fan motor assembly in the correct location.
2 Fix the DC fan motor assembly to the unit by tightening the screws.
4
199].
4
254].
b d b c
a
"4.15.2 Repair
"4.15.2 Repair
"To prevent
4
procedures" [ 199].
EBLA04~08E + EDLA04~08E
Daikin Altherma 3 M
ESIE22-09 – 2022.05