ACME Dotline 360 User Manual page 32

Zoom 1/2 Reset Error
Fan 1/2/3/4/5 Err
Temperature Error
Temp. is too High
Check whether the position of the zoom where the magnet is
installed falls off or is damaged.
Check whether there are obstacles in the zoom operating range.
Check whether the Hall element on the zoom is damaged.
Check whether the lead connecting the Hall element on the zoom and
the PCB board is in poor contact or disconnected.
Check whether the motor on the zoom is damaged.
Check whether the related circuit of the motor drive board on the
zoom is damage.
Check whether the fan is not running.
Check whether the fan leads are installed in place or disconnected.
Check whether the fan is damaged.
Check whether there are obstacles in the fan operating range.
Check whether the fan circuit on the motherboard breaks down.
Check whether the component is damaged.
Check whether the fan is out of order.
Check whether the temperature detecting board is normal.
Check whether the components of the temperature detecting board
are damaged.
Check whether the lead on the temperature detecting board is
installed in place or disconnected.
Check if the fan is working properly.
Check if the fan speed is normal.
Check if the ambient temperature is abnormal.
- 31 -