Table of Contents
Advertisement
If you use a universal DMX controller to control the units, you have to set DMX address
between 1 and 512 so that the units can receive DMX signal.
Press the MENU button to access the control menus, select DMX Setting, press the ENTER
button to confirm. Use the UP/DOWN button to select DMX Address, press the ENTER
button to confirm, the present address will show on the display. Use the UP/DOWN button
to adjust the address between 001 and 512, press the ENTER button to store. To exit the
menu, press MENU, or wait 30 seconds.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel Mode
57 channels
14 channels
9+ channels
(Controlled by DMX)
9+ channels
(Controlled by Art-Net)
Please control the fixture by referring to the configurations below.
Attentions:
The unit will maintain the last condition until reset if you cut-off the DMX signal.
For the channel Function, keep the value for about 3 seconds, then the
corresponding function will take into effect.
6.2 Address Setting
Unit 1
Unit 2
Address
Address
1
1
1
1
6.3 DMX512 Configuration
- 21 -
Unit 3
Address
58
105
15
29
10
19
49
97
Unit 4
Address
162
43
28
145
Advertisement
Table of Contents
