ACME Dotline 360 User Manual page 12

Channel Mode
RDM Device ID
Mode 3 DMX Addr
Mode 3 ART Addr
DMX Last State
Select DMX Channel Mode, press ENTER.
Use UP/DOWN button to select between 57 CH, 14 CH and 9+, confirm
your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select RDM Device ID, press ENTER.
The RDM device ID is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select Mode 3 DMX Addr, press ENTER.
Use UP/DOWN button to select a DMX address from 1 to 504, confirm
your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select Mode 3 ART Addr, press ENTER.
Use UP/DOWN button to select a Artnet address from 1 to 465, confirm
your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select DMX Last State, press ENTER.
Use UP/DOWN button to select one of the following status:
Blackout (Fixture blacks out if DMX signal stops)
Hold (The device continues to operate in the current mode with the last
active DMX values until the signal returns)
Manual (The device accepts the DMX value stored in the 'Manual Mode'
menu)
Confirm your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
- 11 -