Second Step Of Configuration: Parameter Menu; Figure 10: Password Screen - Riello NXHP Series Installation, Operation And Maintenance Instructions

3 - INSTALLATION OF SYSTEM
To access the time configuration menu, press and hold the
Schedule key for 2 seconds.
3.2.1 - Day of week setting
The current day starts flashing.
If necessary, press the Down key or the Up key to change the
day of the week.
Press the Schedule key to confirm your selection and go to the
next parameter.
3.2.2 - Time format setting
Once the day of the week has been confirmed, set the time format.
Press the Down key or the Up key to change the time format.
12-hour format
Press the Schedule key to confirm the time display.
3.2.3 - Time setting
Once the time format has been confirmed, set the time.
Press the Down key or the Up key to set the time.
For 24-hour format: Set the hour and press the Schedule key to
confirm. Then, set minutes and press the Schedule key to confirm.
To confirm all changes, press and hold the Schedule key for 2
seconds.
3.3 - Second step of configuration: Parameter
menu
According to the application of unit, several parameters are to be
configured to allow the correct operation of system. The following
sections explain some standard cases of installation. But to
configure the unit, it is necessary to access the parameter menu.
If there is no user interface on the unit, it is necessary to use
Customer communication bus (Proprietary Protocol or Jbus) to
configure the unit. Otherwise in the case with user interface, follow
the next procedure.
3.3.1 - To access the parameter menu
If the user interface is in standby mode, press one key to activate
the WUI screen.
Press and hold the Occupancy key and the Schedule key
simultaneously for 2 seconds.
The password screen is displayed.
24-hour format
Enter the password: 0120.
To change the number, press the Up or Down key.
To validate each number, press the Schedule key.

Figure 10: Password screen

or
35