KPM PROCESS SENSORS METIS M311 Operating Manual page 78

vm X
vq X
vt (vm) X
In addition, for devices with built-in motorized focus
moa XXXX
In addition, for devices with built-in PID controller
hz XXXX
ob XXXX
rg X
ro XX
r0 (ro0) X
rz XXXX
sg1 XXXX
sg2 XXXX
sw XXXX
td XXXXXX
ti XXXXXX
xa XXXX
xb XXXX
xl XXXX
xp XXXX
ym XXXX
ys XXXX
yx XXXX
In addition, for devices with Profibus / Profinet
fpa XX
fbm
78 / 81
METIS M311 / M322 / H311 / H322 (12-pin device connector)
Color transmission system camera module
X = 0 = NTSC; 1 = PAL
Image setting color / monochrome
X = 0 = color image; 1 = monochrome image
Test image:
X = 0 = normal image; 1 = test image
Focus distance
XXXX in mm (may be rounded up or down in 10 mm resolution!)
Hold time:
XXXX = 0x0000...ffff (in ms)
Next controller start with AutoTune
XXXX = 0x00C8...03E8 (20.0 to 100.0% in 0.1% steps)
Controller handle
X = 0 = Stop controller 1 = Start controller 3 = Controller with AutoTune
Controller options: Bit 0 = Clear of Ti (sets the integration sum of the PID control to 0
to prevent an undershoot if a control process is done from a higher to a lower value),
Bit 4 = AutoTune optimization at every control start
Controller options (not memory-resistant)
bit0 = next controller start with AutoTune
Ramp time in ms
XXXX = 0x0000...ffff
Temperature deviation from setpoint value ± 3000° for limit value 1
XXXX = 0x8AD0...7530 (in two's complement, 1/10 degree)
Temperature deviation from setpoint value ± 3000° for limit value 2
XXXX = 0x8AD0...7530 (in two's complement, 1/10 degree)
Setpoint value (XXXX in 1/10 degree)
Derivative time constant Td (in sampling times)
XXXXXX = 0x000000...00ffff
Integral time constant Ti (in sampling times)
XXXXXX = 0x000000...00ffff
Sampling time in 10 µs steps
M3: XXXX = 0x0064...09C4 (1 ms to 25 ms),
H3: XXXX = 0x000A...09C4 (0.1 ms to 25 ms)
Setpoint deviation (in 1/10 degree)
P dynamic
XXXX = 0x0000...2710 (0.01 to 100.00%; 0.01% steps)
Proportional band Xp
XXXX = 0x0000...2710 (0.1 to 1000.0%; 0.1% steps)
Minimum control output power Pmin
XXXX = 0x0000...03E7 (0.0 to 99.9%; 0.1% steps)
P-zs
XXXX = 0x0000...03E8 (0.0 to 100.0%; 0.1% steps)
P-max
XXXX = 0001...03E8 (0.1 to 100.0%; 0.1% steps)
Fieldbus address: 00...7fh (only Profibus)
Fieldbus mode (00, 01, 02)