Status Leds Profinet; Devices With Additional Ethernet Connection; Pinout Ethernet; Status Leds Ethernet - KPM PROCESS SENSORS METIS M311 Operating Manual

METIS M311 / M322 / H311 / H322 (12-pin device connector)

4.2.2.1 Status LEDs Profinet

Module status
Off
Green
Green flashing, 1x
Red
Red
Alternating red / green Firmware update
Link / activity for A
Off
Green
Green, flickering
4.3

Devices with additional Ethernet Connection

The Ethernet interface is used for the digital communication of one or more pyrometers over the network. It is
available in addition to the serial RS232 or RS485 interface. The connection is made in accordance with the
applicable bus specifications.
The maximum possible transmission speed is limited by the cable length:
▪ 100 m according to Ethernet standard (Cat5 / Cat6 cable).

4.3.1 Pinout Ethernet

M12 4-pin
connector,
female

4.3.1.1 Status LEDs Ethernet

Operating mode
Green
Green flashing
Orange
Orange flashing
Red flashing
Description
Not Initialized
Normal operation
Diagnostic
event(s)
Exception error
(combined with
red network sta-
tus LED) Fatal
event
Description
No link
Link
Activity
1) TX+
2) TX-
3) RX+
4) RX-
Description
DHCP
DHCP + active
socket connection
Fixed IP address
Fixed IP address
+ active socket
connection
IP error
Network status
Off
Green
B
Green flashing, 1x
Green flashing
Red
A
Red flashing, 1x
Red flashing, 2x
Red flashing, 3x
Link / activity for B
Off
Green
Green, flickering
1) TX+
2) TX-
3) RX+
6) RX-
Not used
Transfer rate
Off
Green
Network status
Green flashing
Description
Offline
Online (run)
Online (stop)
Blink
(combined with red module
status LED) Fatal event
Station name error
IP address error
Configuration error
Description
No link
Link
Activity
7 8
6
4 5
3
1 2
RJ45 plug
Description
10 Mbit
100 Mbit
Description
Network traffic
17 / 81