Control Window - KPM PROCESS SENSORS METIS M311 Operating Manual

7.1.4 Control Window

It is helpful when switching to another tab (e.g. to the graph display).
2C: 2-color measuring temperature,
C1: 1-color meas. temp. channel 1,
C2: 1-color meas. temp. channel 2,
("Under" or "Over" when falling below
or exceeding the beginning / end of
the temperature range)
Large setpoint display for devices
with PID controller
LED symbols for status of the digi-
tal inputs / outputs
Expand to display rarely used
settings, such as window transmit-
tance and spot size filling.
Parameter slider from active input
field (click first)
INFO
On the emissivity shown in red: Emissivity, transmittance
and spot size fill factor are directly related to each other, the result of
the multiplication of the 3 parameters has to be minimum 5%. If the
multiplication of the 3 parameters falls below 5%, the values are dis-
played in red.
INFO
On the emissivity displayed
in violet: indicates that something is
misaligned in the lower (possibly col-
lapsed) area.
38 / 81
A separate control window also provides all available measurement-related functions and
settings.
METIS M311 / M322 / H311 / H322 (12-pin device connector)
Internal device temperature (see 5.3)
Measurement mode (2C, C1, C2)
response time
Peak Picker
Measurement parameters
Emissivity
Switch-off
Switch-off
Emissivity
and transmittance
and spot size
Parameter changes are immedi-
ately transferred to the pyrometer
with the enter key.
(measurement speed)
on/off
Slope,
Level,
Verification,
of each single channel
fill factor.