Meter Components - Emerson Rosemount 3410 Series Installation Manual

Installation manual
00825-0600-3104
2.2

Meter components

Rosemount
at the factory. The meter components include the transmitter electronics enclosure, the
base electronics enclosure and the meter body with transducer assemblies
WARNING
Contents may be under pressure.
When the meter is under pressure, DO NOT attempt to remove or adjust the transducer
holder.
Attempting to do so could release pressurized gases, resulting in serious injury or
equipment damage.
WARNING
Contents may be hazardous.
The meter must be fully depressurized and drained before attempting to remove the T-200
transducer assembly. If gas or fluid begins to leak from the T-200 transducer stalk
assembly, stop immediately and reinstall T-200 stalk assembly.
Failure to comply could cause serious injury or equipment damage.
A. Transducer holder
WARNING
Explosion or fire hazard
Conduit runs must have a sealing fitting within 18 in. (457 mm) of the enclosure to reduce
the risk of an explosion or a fire.
• During operation, keep covers tight.
• During equipment maintenance, disconnect power before opening transmitter or base
electronics. Clean cover joints before replacing.
• DO NOT substitute meter components. Component substituting may compromise the
intrinsic safety.
Failure to comply could result in severe injury to personnel or cause damage to the
equipment.
The 3414 four path ultrasonic meter components are shown below.
(2) Refer to the 00809-0200-3417 Split Clamp Extractor Tool Operation Manual to remove the transducer holders
while the meter is pressurized.
Installation manual
3410 Series Gas Ultrasonic Flow Meters are assembled, configured and tested
™
Mechanical installation
October 2023
(2) .
23