Meter Components - Emerson Rosemount 3414 Installation Manual

Installation manual
00825-0600-3104
CAUTION
ESCAPING GASES OR FLUIDS HAZARD
Process Seal Materials Single Seal Certification (T-XX and T-200 Transducers)
• Wetted material for T-XX style transducers are 316SS or Inconel holders with
Hastelloy-C pins, Stycast 2850 Epoxy, and glass.
• Wetted materials for T-200 Style transducers are Titanium housing and NBR
(Nitrile) or FKM (Viton) O-ring material.
Only Rosemount
ring materials for T-200 transducers. No substitutions are allowed to maintain
process seal integrity.
Verify chemical compatibility of material with components of process fluid.
Reference Parker Seals – Chemical Compatibility Catalog EPS 5350
• www.parker.com/literature/Engineered%20Polymer%20Systems/
5350_Appendixh.pdf
Failure to select the suitable meter seals may cause escaping gases or liquids,
resulting in injury or equipment damage.
Consult your Emerson Flow sales and service representative to ensure you
purchase the correct components and seals for your application.
2.2

Meter components

Rosemount
and tested at the factory. The meter components include the transmitter
electronics enclosure, the base electronics enclosure and the meter body with
transducer assemblies
WARNING
CONTENTS MAY BE UNDER PRESSURE
When the meter is under pressure, DO NOT attempt to remove or adjust the
transducer holder.
Attempting to do so could release pressurized gases, resulting in serious injury or
equipment damage.
(2) Refer to the 00809-0200-3417 Split Clamp Extractor Tool Operation Manual to remove the transducer holders
while the meter is pressurized.
Installation manual
specified o-ring replacements shall be used for process seal o-
™
3410 Series Gas Ultrasonic Flow Meters are assembled, configured
™
(2) .
Mechanical installation
January 2023
27