Emerson Rosemount 3410 Series Installation Manual page 83

Installation manual
00825-0600-3104
Figure 4-8: AMS Device Manager - Configure Manual Setup
Procedure
1. Remove security wires from the endcap and the Bracket/Cover hex head bolts that
2. Disable the Write Protect switch in the CPU Module to write any of the following
3. Click the HART tab. The Primary and Secondary variables are read-only and are
4. Click the Units button in HART tab (see from AMS Device Manager - Guided setup,
5. Click the Analog Output 1 button in Outputs tab (see AMS Device Manager - Guided
6. Click the Analog Output 2 button in Outputs tab. Follow the configuration
7. Click the Frequency/Digital Outputs button in Outputs tab. Follow the configuration
8. Click the Frequency and Digital Output 1 tab. Follow the configuration instructions
Installation manual
secures the Base Enclosure if they are installed.
configuration parameters to your meter.
configured for Uncorrected Flow Rate. The Third and Fourth variable configuration
choices include Pressure and Temperature.
Step 2).
Setup, Step 3).
instructions in the AMS Device Manager - Guided Setup, Step 3. The read-only
Secondary variable Content, Uncorrected Flow Rate, displays. Use the dropdown
arrow and select the (flow) Direction - Forward or Reverse. Enter a Lower and Upper
Range limit. Set the Alarm Action parameters.
a) Click Apply, after you enter the data to write the parameters to the meter.
instructions in the Step 4a.
Note
If changes are made to any Source variable on this page, apply the changes and
navigate to the Guided Setup page. Navigate back to the Manual Setup for the
changes to be reflected in other Manual Setup pages.
a) Click Apply, after you enter the data to write the parameters to the meter.
in the Step 4b.
Configuration
October 2023
83