Emerson Rosemount 3410 Series Installation Manual page 81

Installation manual
00825-0600-3104
5. Click Setup HART to configure the HART
6. Click Alert Setup on the Overview page and select the Flow Analysis tab and enable
7. Click the Service Tools tab on the Overview page and select the Variables tab. The
Installation manual
Note
If changes are made to any Source variable on this page, apply the changes
and navigate to the Guided Setup page. Navigate back to the Manual Setup
for the changes to be reflected in other Manual Setup pages.
b) Click the Frequency and Digital Output 1 tab to configure the Content, (flow)
Direction, Channel B Phase frequency output, Lag forward, Lead Reverse or
Lead Forward, Lag Reverse (Phase B lags Phase A while reporting forward
flow and lead Phase A while reporting reverse flow or the opposite), Digital
Output 1 Channel A Content and Polarity, Channel B Content and Polarity,
Maximum Frequency, and Lower and Upper Range Units of Measure.
c) Click the Frequency and Digital Output 2 tab and repeat
Frequency and Digital Output 2 parameters.
text, Final Assembly number, Poll address and number of response preambles are
displayed). After all of the data is entered click Apply to write the parameters to the
meter.
Reverse Flow. Click the OK button to return to the Overview page.
Flow Data, Path Information, Flow Totals, and All Variables data is populated after
you are connected to the meter.
a) Click the Flow Data tab and view the Flow Direction (Forward or Reverse),
Average Flow and Average Sound Velocities values.
b) Click the Path Information tab and view the Chord performance, Gain, SNR
(Signal to Noise Ratio) Signal strength (mV), and Noise (mV).
c) Click the Flow Totals tab to view the volume totals (forward and reverse
uncorrected volume).
d) Click the All Variables tab to view a graphical display of the Primary,
Secondary, Third and Fourth Variables.
Step 3b
parameters (tag, date, descriptor, message
®
Configuration
October 2023
to configure
81