Table of Contents
Advertisement
23.3 Reticle
adiustments
ZA
296" 30' 00"
HAR
198" 34' 10"
6)
Calculate Horizontal angle
A
and
Vertical angle B,
A
=
(a2+a1)/2+90°=198034'10"
7)
While still sighting the target on
face right, use the horizontal and
vertical fine motion screws to ad-
just the displayed horizontal and
vertical angles to the above val-
ues.
8) Look through the telescope. The
reticle is now slightly shiftedfrom
the target.
9)
Unscrew the two fixing screws
and remove the telescope reticle
cover
@.
10) To move the vertical reticle line
towards the target centre, use the
adjusting pin to adjust the left and
right adjusting screws as follows:
Slightly loosen the top and bot-
tom adjusting screws by the same
amount.
To move the reticle to the r i g h ~
(left), first very slightly loosen the
deft
(right) adjusting screw, then
tighten the rlgkit (left) adjusting
screw by this same amount.
[ (
)
for opposite direction]
Advertisement
Table of Contents
