Table of Contents
Advertisement
20. SETTING-OUT MEASUREMENT
(start coordinates S - 0 measurement, and determine the height)
/
//"
the
t o
be
polnt
set
out
(?
$ ;
10) When "H" has become 0.000 m,
press
and then
.
The setting-out measurement is
started, and then the coordinate
measurement is started.
After about 5.1 seconds (Fine
measurement mode), the coordi-
nates from the setting-out data to
t h e reflecting p r i s m are dis-
played.
Since the horizontal angle and
horizontal distance have already
been determined, the N and E
coordinates are "0"
11) Move the reflecting prism up or
down until the Z coordinate be-
comes 0.000, and determine the
height.
The tip of the pole is the point to
be set out.
If the Repeat measurement mode
has been selected, press
to
stop the measurement.
Advertisement
Table of Contents
