Table of Contents
Advertisement
5-11 Setting for Video Editing
System Connection Using the BVE-9100/2000/910 and PVE-500 Editing Control Unit
Connection
Reference video signal
Reference video signal
Editing Control Unit
REF VIDEO IN
EO 800/DABK-801
9-pin serial remote
Notes on video editing
* The DMC function cannot be used.
* Be sure to record time code on the tape prior to audio recording.
First edit cannot be performed on the PCM-800 which does not
support the assemble recording.
* When using the BVE-2000, set the channel A3 to the A3 key. No
channel is assigned to the A3 key in the default setting.
* Set the preroll time to 7 seconds in sync play.
Setting on the BVE-9100/2000/910 Editing Control Unit
Set the TC SOURCE in the AUX mode to "LTC," " LTC+,"
"LTC: VITC" or "LTC: VITC+."
Set the VTR constants as follows:
Setup parameter for the BVE-910/BKE-904
[—__
eve area [aves ore
CONSTANTS
| 70" | 06 | 00] 56 |
[cONSTANT2
| oA | 05 | FF | 00 |
vir
conris. | -_|
1) NTSC: 70, PAL:71.
2)NTSC:96,PAL:7D
3) NTSC: 5C, PAL: 4C
Setup parameter for the BVE-2000
|
CS TE-+ [BYTE-2 [BYTE-3 [BYTE-4 [BYTE-5 [BYTE-6 [BYTE-7|
PeONSTANTT | 707-03 | 00 | 96° | 02 | 02 | 02]
| CONSTANT-2_
| 0A | 05 | FF [ 00 | 00 | 5c | FF |
AUDIO CH ASSIGN Ha | A2 | Hee
VTRCONFIG.
| - |
3[BYTE.
[00 | 26" |
FCONSTANT:2
| 8]
00 |
ae
AUDIO CHASSIGN
VTR CONFIG.
5-41
Chapter 5 Operation
chapt
> WIK
Advertisement
Table of Contents
