Sony PCM-800 Operation Manual page 97

Checking cue points
Changing cue points
DOWN UP
Baw
Advanced recalling
1 Press RCL.
2 Press two digits which represent the memory from which you wish
to recall a cue point.
The cue point in that register will be recalled into the LOCATE
TIME window as soon as you enter two digits.
To finely tune a cue point recalled into the LOCATE TIME
window
1 Press UP or DOWN until the display shows the correct time point.
2 Enter a two-digit MEMORY NO. to store the finely tuned cue
point into memory.
The previous cue point in that memory is erased.
To entirely change any recalled cue point
Perform one of the "Setting cue points" procedures. Each time you
store a new cue point into any MEMORY NO. register, the previous
memory in that register is erased.
Pressing IN, OUT, START or END key will recall the corresponding
points from memory and load it into the LOCATE TIME window.
The corresponding indicator will also light.
Furthermore, if a preroll time is previously entered and you press
PRE, the point where the preroll starts from is displayed in the
LOCATE TIME window. ;
So you can be promptly locate the tape to that point using LOC.
Autolocating to one of the 99 cue points
MENU
Before actually autolocating the tape to any cue point, note that you
can autolocate the tape to a point optionally set time before any cue
point you select. The length of this Locate Preroll time defaults to 0.
To enter a Locate Preroll time
1 Press MENU until the LCD screen reads :
Locate Preroii
00 Min 00 Sec
(Continuei)
Chapter 6 Operation Using the RM-D800 Remote Control Unit | 6-7
Chapte 6 HA