Table of Contents
Advertisement
repens
lll
A-4
DABK-801 Setting for MIDI Control
Ea
EAS
RY
9
A
Appendixes
f= "MMC Response cable mute"
Always "0" (MTC will be transmitted on the MMC Response
cable).
.
Time Code Source
Cannot be changed via MIDI.
Returned data for a READ command will be as follows.
When the generator on the DABK-801 is stopped,
01 (Selected Time code) if S1 bit No. 6=1, or
02 (Selected Master code) if S1 bit No. 6=0
or when the DABK-801 generator is running,
06 (Generator Time Code).
Device Numbers
To yield the DABK-801 to controllers with MMC standard, you have
to number the DABK-801 the same as on the part of the controller in
use.
Device numbers (also called channel numbers, device ID numbers or
others) you can assign to the DABK-801 is from 1 to 16 depending on
the setting of the internal switch of the DABK-801.
If the device numbers your controller can handle start from 0 (not
from.1), add 1 to the device number you assigned to the DABK-801
on the part of your controller. The sum is the device number selected
by the internal switch (e.g. if you assign 1 to the DABK-801 on the
part of the controller, the DABK-801 must be numbered 2 on the part
of the DABK-801.
If you use a single controller to control multiple units with MMC
standard, each of them must have a different device number. The same
is also true for the same model units (e.g. if two or more DABK-801s
are connected to your controller, you have to assign a differentn umber
to each of them as you will do on the part of the controller).
Advertisement
Table of Contents
