Table of Contents
Advertisement
Lowy ay VOi ce) (eler-}
ile) am Oxelalige) i=
Setting locating points
MEMO 1
DISPLAY
Two locating points (MEMO 1 and MEMO 2) can be specified on a
given tape.
To set MEMO points
Press MEMO (1 or 2) at the desired point during Play, or during Stop
if the tape is at the point you wish to specify as a locating point.
To check MEMO points
Press the DISPLAY key (when the tape stops or is running) until the
MEMO 1 (or 2) indicator lights. The display is now showing the
location stored into the corresponding register.
To finely tune MEMO points:
When the MEMO point you wish to finely tune is showing in the
display, press A to increment the numbers shown, or press W to
decrement them.
To speed up the tuning, you can hold down either A or V and press
DISPLAY.
Each time you press DISPLAY, the next upper (left) two digits will
fast increment.
To clear MEMO points
Hold either A or W and press the other. The locating point currently
shown in the display is erased from memory, as confirmed by
"00:00:00:00" appearing instead.
To autolocate the tape to MEMO points
Press LOC 1 to locate the tape to the MEMO 1 point. Press LOC 2 to
locate the tape to the MEMO 2 point.
At the end of locating functions the tape will stop unless AUTO PLAY
is previously pressed.
° The LOC keys cannot operate during rewind, punch-in/out process,
or when two or more PCM-800s are hooked up and the slaves are
chasing the master.
* The PCM-800 cannot normally capture a locating point if no time
code is recorded on the inserted tape. In this case, "no t.codE"
appears in the display when you press MEMO 1 or MEMO 2.
To perform autolocate functions on an ABS time only tape (no TC),
change the time mode to ABS as described on the next page.
Chapter 5 Operation | 5-13
Chap S HI
Advertisement
Table of Contents
