Table of Contents
Advertisement
55: PLAY SPEED REFERENCE
Cannot be set via MIDI.
Returned data fora READ command will be
00 when the PCM-800 clock source is Internal, or
01 when the PCM-800 clock source is Word or Video.
59: RESOLVED PLAY MODE
Cannot be set via MIDI.
Returned data for a READ command will be
00 (Normal) when S1 bit No. 7 is "1", or
01 (Free Resolve mode) when S1 bit No. 7 is "0".
5A: CHASE MODE
Cannot be set via MIDI.
Returned data for a READ command will be
00 (Absolute Standard mode) when S1 bit No. 3 is "1", or
01 (Free Resolve mode) when S1 bit No. 3 is "0".
5C: GENERATOR SETUP
The "Frame Sync Reference for Run mode" cannot be set via MIDI.
5E: MIDI TIME CODE COMMAND TALLY
;
The initial condition at the power up is determined by the DIP switch.
If an MIDI TIME CODE COMMAND comes Lae the MTC output
status will be changed.
$2-8 =1
mm=00 the DABK-801 does not output MTC
$2-8=0
mm=02 the DABK-801 outputs MTC
5F: MIDI TIME CODE SETUP
MTC flags
a= "Transmit while stopped"
The initial condition is"
"1" (Continue transmission) when S2-6 = 0, or
"0" (No MTC output while stopped) when S2-6 = 1.
Can be changed via MMC.
b= "Stopped" data type
Always "1" (full message).
Cannot be changed.
c= "Transmit while fast"
"1" (Continue transmission) when S2-7 = 0, or
"0" (No MTC output while stopped) when S2-7 = 1.
Can be changed via MMC.
d= "Fast" data type
Always "1" (full message).
Cannot be changed.
e= "Transmit user bits"
Always "0" (Inhibit).
Cannot be changed.
Appendixe
A-3
Appenc HII
Advertisement
Table of Contents
