Table of Contents
Advertisement
Setting punch-in and out points
7 Use one of the following three procedures:
A. By cueing up the VTR
(1) Use the JOG/SHUTTLE dial to locate the VTR to the point
where you want the PCM-800 to drop into record.
(2) Hold IN and press STR.
The cued-up time code point (displayed in the TAPE TIME
window) is stored in the VTR, as well as in the PCM-800.
(3) Use the JOG/SHUTTLE again to locate the desired punch-out
this time.
(4) Hold OUT and press STR to store the cued-up point.
B. Using the RECORD key
(1) Check to see that no REC FUNCTION key is pressed.
(2) Press PLAY to let the VTR start to play.
(3) Watch the video picture, and at the desired moment, press
RECORD.
The time code point shown in the TAPE TIME window at this
moment is stored as the punch-in point, both in the PCM-800
and VTR.
(4) Press RECORD again at the desired moment to select the
punch-out point.
C_ Using the numeric keypad
Use this procedure if the necessary punch-in and out points are
known to you.
(1) Enter the desired punch-in point into the LOCATE TIME
window using the numeric keypad.
(2) Press STR, then IN.
The entered point is stored both in the PCM-800 and VTR.
(3) Enter the desired punch-out point on the numeric keypad.
(4) Press STR, then OUT to store the point.
(Continued)
Chapter 6 Operation Using the RM-D800 as Slave (with the DABK-801;
6-29
ensnr THM
Advertisement
Table of Contents
