RLS-2020V 1.x.x (xxxx/xx/xx)
Apply settings
Detection range
Detection profile 1
Laser settings
Detection profile 2
Input
Angle correction
Event code
Laser settings
Camera settings
*
ONVIF media profile
View
Area set mode
Event log
Date and Time
Output off delay (sec.)
Network
Security
Maintenance
Information
(Bold letters = advanced settings)
*
= RLS-2020V only
Save
0
Use wall tamper
Always turn on LEDs
Auto
2
5-3. Laser settings
Angle correction
Normal resolution
?
High resolution
The angle of the detection area is corrected in the software
using this setting.
Use wall tamper
Turn it off when the wall tamper switch may not be
pressed properly, for example mounting on a pole.
Always turn on LEDs
Area set mode
[ Auto, Indoor option, Outdoor option ]
In most situations leave as default "Auto", because the area set is
optimized according to the Indoor/Outdoor mode. Select 2 type of
options, only if "Auto" can not work properly.
Output off delay (sec.)
[ 0.1 to 60
( = 1 min.)
41
5. Advanced Settings
[ -2.25° to +2.5° ]
[ -2.375° to +2.5° ]
]