Table of Contents
Advertisement
ENOW00014-0
CAUTION
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
Always use a fully charged battery.
ENOW00015-0
CAUTION
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-C
Note
Minimum batter y requirements:: 12V
40Ah/20HR, 330 Cold Cranking Amps
(CCA) Specifications and features of bat-
teries vary among the manufacturers. Con-
sult the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Connect the battery cable to the
leads that come from the bottom
cowl.
2. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
3. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on
it to prevent short circuits.
1
+
2
-
1. Battery cord (red)
2. Battery cord (black)
ENOM00726-B
4. Altitude adjustment kit
Installation
High altitude:
When engine operates at high altitude
(over 1000m/3280ft) engine may need
to have a high altitude kit installed. Oth-
erwise, operating the engine at high alti-
tude may increase its emissions and
decrease fuel efficiency and perfor-
mance. Contact authorized Tohatsu
dealer for more detail.
21
INSTALLATION
5
ENOF01508-0
Advertisement
Table of Contents
