Table of Contents
Advertisement
Installation
Procedure
1. Prepare the wire:
a. Cut the PE wire (A). Make sure
b. Strip the insulation from the end
c. Attach the cable lug to the end of
2. Attach the PE wire to the PE busbar.
Use the fasteners (D).
3. Tighten the fasteners to the correct
torque. For the specification, refer to
section 10.7.
5.6.3
Connect the enclosure to the earth
Preliminary requirements
Procedure
1. Connect the earthing conductor (B) to
the pin (A) of the enclosure.
2. Connect the earthing conductor to the
earthing electrode (C).
50
•
Wire stripper pliers, cable
lug tool and torque socket
wrench. Refer to section
10.5.
that the length is sufficient for
connection at the PE busbar (B).
of the wire. Make sure that the
strip length is compatible with the
cable lug (C).
the wire. Use the cable lug tool.
•
Installation engineer
•
Cable lugs and fasteners.
Refer to section 10.6.
Note: It is possible
to connect more that
one EVSE to a single
earthing electrode, if sized
accordingly.
D
C
B
A
•
•
Make sure that the earthing
connection is in accordance
with with the standard IEC
60364-5-54.
C
B
9AKK108466A3703-EN | 001
A
B
Advertisement
Table of Contents
