Appendix B: Installation Of Optional Pushbuttons - Crestron STX-1700CW Operation Manual

Wall Mount 2-Way RF Compact Color Touchpanel

Appendix B: Installation of Optional Pushbuttons

36 • Wall Mount 2-Way RF Compact Color Touchpanel: STX-1700CW
The STX-1700CW is supplied with ten optional pushbutton switches, blank buttons,
and a bezel to accommodate the switches. As a further option, custom engraved black
buttons (1700C-BTNB) or silver buttons (1700C-BTNS) can be designed and
purchased via the Crestron Engraver software. Version 2.3.0.0 or later is available
from the Crestron website.
Perform the following to install pushbuttons on the STX-1700CW. Follow these same
basic procedures to replace the blank buttons with the optional engraved buttons. A #1
Phillips screwdriver is required. Refer to the illustration below.
1. Place the touchpanel face down on a clean work surface.
2. Remove the four screws securing the front bezel to the base. Holding the
bezel to the base, return the unit to its normal position and lift the bezel from
the base.
3. Assemble the supplied membrane switches to the pushbutton sets. Notice
that the pushbutton sets fit snugly on the membrane switches. (Refer to the
following Notes.)
4. Put the assembled pushbuttons and switches in place (refer to the following
Notes), and place the new bezel in position.
NOTE: The rear of the pushbuttons are marked 1-5 TOP and 6-10 TOP to ensure
correct orientation when installed. Do not remove the plastic frame connecting the
buttons together.
NOTE: Carefully position the switch/pushbutton assemblies on the printed circuit
boards–edges should be aligned–and place the bezel over the pushbuttons to hold
them in place.
5. Hold the bezel in position and turn the unit over on its face.
6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,
being careful not to strip the threads.
7. Verify that the pushbuttons function properly.
Optional Pushbutton Installation Diagram
Bezel
5
Crestron STX-1700CW
Screw
Bottom view
Pushbuttons
Membrane
Switches
10
Operations Guide – DOC. 6228A
Screw