Appendix: Installation Of Optional Pushbuttons - Crestron TPS-1700 Operation Manual

Wired 5.7 inch tabletop touchpanel
Hide thumbs Also See for TPS-1700:
Table of Contents

Advertisement

Crestron TPS-1700

Appendix: Installation of Optional Pushbuttons

Operations Guide - DOC. 6223A
®
Isys
The TPS-1700 is supplied with ten optional pushbutton switches, blank buttons, and
a bezel to accommodate the switches. As a further option, custom engraved black or
silver buttons (1700C-BTNB or 1700C-BTNS) can be designed and purchased via
the Crestron Engraver software. Version 2.3.0.0 or later is available from the
Downloads | Software Updates section of the Crestron website (www.crestron.com).
Perform the following to install pushbuttons on the TPS-1700. Follow these same
basic procedures to replace the blank buttons with the optional engraved buttons. A
#1 Phillips screwdriver is required. Refer to the illustration below.
1. Place the touchpanel face down on a clean work surface.
2. Remove the four screws securing the front bezel to the base. Holding the
bezel to the base, return the unit to its normal position and lift the bezel
from the base.
3. Assemble the supplied membrane switches to the pushbutton sets. Notice
that the pushbutton sets fit snugly on the membrane switches. (Refer to the
following Notes.)
4. Put the assembled pushbuttons and switches in place (refer to the following
Notes), and place the new bezel in position.
NOTE: The rear of the pushbuttons are marked TOP 1-5 and 6-10 to ensure correct
orientation when installed. Do not remove the plastic frame connecting the buttons
together.
NOTE: Carefully position the switch/pushbutton assemblies on the printed circuit
boards–edges should be aligned–and place the bezel over the pushbuttons to hold
them in place.
5. Hold the bezel in position and turn the unit over on its face.
6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,
being careful not to strip the threads.
7. Verify that the pushbuttons function properly.
Optional Pushbutton Installation Diagram
Bezel
5
Isys
Wired 5.7 Inch Tabletop Touchpanel
Screw
Bottom view
Pushbuttons
10
®
Wired 5.7 Inch Tabletop Touchpanel: TPS-1700 • 27
Screw
Membrane
Switches

Advertisement

Table of Contents
loading

This manual is also suitable for:

Isys tps-1700

Table of Contents