Table of Contents
Advertisement
Crestron STX-1700CW
CRESNET INTERFACE MENU
03
RF SETUP
1
KEY CLICK SETUP
Operations Guide - DOC. 6228A
Wall Mount 2-Way RF Compact Color Touchpanel
Cresnet Interface Menu
CRESNET ID is a two-digit hexadecimal number that can range from 03 to FE. Note
that this number and the Net ID set in the SIMPL Windows program of the Cresnet
system must match when operating as a wired touchpanel and for file transfers. Net
ID for the STX-1700CW is factory set to 03.
The UP and DOWN buttons increase and decrease the CRESNET ID by one digit
(i.e., 03, 04, 05, . . .FE).
Select the Return button to return to the SELECT INTERFACE screen.
RF Setup
The radio frequency identity number (RF ID) is necessary to secure RF
communications such that controls can be activated from the touchpanel. The RF ID
consists of a one-digit hexadecimal number. The touchpanel can be set to one of
fifteen numbers; "1" is shown as an example in the illustration and is the default.
The RF ID setting should match the value assigned to the STX-1700CW touchpanel
definition in the SIMPL Windows program. Refer to page 17 for information about
SIMPL programming/setup for this touchpanel.
The UP and DOWN buttons increase and decrease the RF ID most significant digit
by one, respectively (i.e., 1, 2, 3, ...F).
The radio frequency channel setting (RF Channel) is necessary for two-way
communication between the touchpanel and the STRFGWX. The RF channel
consists of a one-digit hexadecimal number. "0" is shown as an example in the
illustration on the left and is the default. The down an up arrow buttons increase and
decrease the most significant digit by one, respectively (i.e., 1, 2, 3, ...F). Refer to
the latest revision of the STRFGWX Operation Guide (Doc. 5811) for more
information on setting up the RF Channel for the RF gateway.
NOTE: The RF TEST MENU button should only be used under supervision from
a Crestron customer service representative during telephone support.
After the Cresnet ID, RF ID and RF Channel settings have been verified, touch the
Return button at the bottom of the screen to save settings and display the SELECT
INTERFACE screen.
Key Click Setup
From the SETUP MENU, press the Key Click Enabled button to open KEY CLICK
SETUP screen. (If the function is currently disabled, the button legend is "Key Click
Disabled.") To enable an audible tone (beep) when the touchpanel buttons are
pressed, select among the Short, Med, or Long KEY CLICK ENABLE/LEN
buttons to set the duration of the tone. The touchpanel responds with a corresponding
signal. To disable the feature, select Click Off.
Use the KEY CLICK VOLUME UP and DOWN buttons to increase and decrease
the volume of the signal. The area to the right of the buttons shows the relative
volume from 0% to 100%, both as a numeric value and, for a quick visual reference,
as an analog bar.
Select the Return button to return to the SETUP MENU
Wall Mount 2-Way RF Compact Color Touchpanel: STX-1700CW • 13
Advertisement
Table of Contents
