Appendix: Engraveable Pushbutton Installation - Crestron ST-1700C Operation Manual

1-Way Wireless RF Touchpanel

Appendix: Engraveable Pushbutton Installation

32 • 1-Way Wireless RF Touchpanel: ST-1700C
Custom-engraved pushbuttons can be obtained by ordering the Customizable
Engraving Button Kit 1700C-BTBN. You can submit the engraving layout in two
ways:
•
Engraving Sheet, Doc. 6069.
•
Engraving Software package, Version 1.1.1.6, available from the Downloads |
Software Updates section of the Crestron website (www.crestron.com).
Perform the following to install engraveable pushbuttons on the ST-1700C. A #1
Phillips screwdriver is required. Refer to the illustration below.
1. Remove the battery, and place the touchpanel face down on a clean work
surface.
2. Remove the four screws securing the front bezel to the base, and return the
unit to its normal position (use care to prevent the bezel from dropping and
becoming damaged).
3. Lift the bezel from the touchpanel, and remove the pushbuttons being
replaced. Note that the pushbutton sets fit snugly.
4. Put the new pushbuttons in place (see following Note), press firmly to ensure
they are seated, and place the bezel back in position.
NOTE: The rear of the pushbuttons are marked TOP 1- TOP 5 and TOP 6 – TOP 10
to ensure correct position and orientation when installed. Do not remove the plastic
frame connecting the buttons together.
5. Hold the bezel in place and turn the unit over on its face.
6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,
being careful not to strip the threads.
7. Reinstall the battery and verify that the pushbuttons function properly.
Engraveable Pushbutton Installation Diagram
Bezel
5
Pushbuttons
Top view with
bezel removed
Crestron ST-1700C
Screw Screw
Bottom view
Battery
10
Operations Guide – DOC. 6050