Crestron STX-1700CW Operation Manual page 29

Wall mount 2-way compact color touchpanel

Hide thumbs Also See for STX-1700CW:

Table of Contents

Crestron STX-1700CW

Operations Guide - DOC. 6228A

Wall Mount 2-Way RF Compact Color Touchpanel

NOTE: Use a standard DB9 male to female "straight-through" cable.

NOTE: You can also dock the STX-1700CW in the DA-1700CW to upload or

upgrade the panel. However, Crestron recommends that you use the connections for

uploading or upgrading that are shown below and described on the next page.

Typical Connection Diagram when Uploading a Project from the PRO2 or equivalent

NOTE: If the control system in use has a 4-pin network connector rather than a

modular (RJ-11 type) NET connector, use an ST-CBL interface cable (sold

separately).

NOTE: To make a cable for either configuration, refer to the "Programming Cable

Specifications" diagram after these notes.

NOTE: An adapter such as a CN-RJ11 (sold separately) is required when using the

RJ-11 cable.

NOTE: The RJ-11 (part of ST-PK) and ST-CBL cables can also be found as part

numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The

database can be downloaded from the Crestron website.

NOTE: The procedure on the next page uses the ST-CBL.

Wall Mount 2-Way RF Compact Color Touchpanel: STX-1700CW • 25

Table of Contents