Workpiece Coordinate System Offset - Mitsubishi Electric 700 Series Training Manual

3. Setup Screen

3.6 Workpiece Coordinate System Offset

This function allows the user to set and display the coordinate system offset controlled by the NC.
Using the option, the number of coordinate system offset sets can be increased by 48 or 96 sets.
(Note) The G92/G52 coordinate system offset cannot be set.
Display items
Display item
(1) Coordinate system offset
area
(2) EXT offset area
(3) G92/G52 offset area
CAUTION
If the tool compensation amount or workpiece coordinate system offset amount is changed during
automatic operation (including during single block stop), the changes will be valid from the
command in next block or after several subsequent blocks.
This sets and displays the offset amount
for the workpiece coordinate system (G54
- G59), or the extension workpiece
coordinate system (G54.1Pn).
Use the menu operation or page change
key to specify which workpiece coordinate
system offset to display or set.
The workpiece coordinate system offset
amount data can be set in absolute or
additional mode.
This displays or sets the offset amount for the external workpiece system.
This displays the offset amount for G92 or the local coordinate system.
The offset amount of the corresponding local coordinate system (G52) is displayed
only when the cursor is at G54 to G59.
125
3.6 Workpiece Coordinate System Offset
Details
Basic machine coodinate system
External workpiece
coordinate system
G55
workpiece
coordinate
system
G54 workpiece
coordinate system
(1)
(2)
(3)
M
Reference
W2
point
W1
R