Mitsubishi Electric 700 Series Training Manual page 134

3. Setup Screen
Menus
Menu
This inputs the offset amount with the absolute mode.
= Input
This inputs the offset amount with the additional mode.
+ Input
This sets the workpiece coordinate system offset so that the current
Easy
machine coordinate becomes the workpiece coordinate zero point.
setting
Only the axis at the cursor position is set.
This displays the G54 - G59 workpiece coordinate system offset
G54-G59
amount. The cursor moves to the G54 offset. This menu can be used
when the G54 – G59 offsets are not displayed.
Enter the P number displayed at the screen to display the extension
workpiece coordinate (G54.1 Pn) offset in the coordinate system
offset area. This menu is not displayed if the extension workpiece
G54.1
P
coordinate system offset option is disabled.
If the local coordinate system offset (G52) displays in the G92/G52
area, the display changes to G92.
This displays the G92 or G52 coordinate system offset amount. The
Coord
G92 offset data is always displayed when the cursor is not at the G54
G92/G52
to G59 offset data.
All coordinate system offset amounts for all axes are erased with the
All
clear exception of G92 and EXT.
This erases the local offset data for all axes corresponding to the
All axs
clear offset data of the coordinate system where the cursor is located.
This can be selected when the number of enabled axes is 6 or over.
Next
The displayed axes are changed to axes 1 – 5, and axis 6 and over.
axis
(Note) This displays when there are 6 or more axes.
3.6 Workpiece Coordinate System Offset
Details
126
Type Reference
C 3.6.1 Setting the
Coordinate System
Offset
C
C 3.6.3 Setting the Work
Piece Coordinate Origin
C 3.6.1 Setting the
Coordinate System
Offset
A
C
A 3.6.2 Erasing the
Coordinate System
Offset Amount
A
C