Mitsubishi Electric 700 Series Training Manual page 57

2. Monitor Screens
(c) Tool nose data
Set the tool nose radius value (tool nose R), wear radius value (R wear) and tool nose point (tool nose
point P) of the tool nose mounted on the tool for each tool used. When the tool offset No. is designated by
the tool command (T command), offset is carried out matching the tool length data and tool nose data.
CAUTION
If the tool offset amount or workpiece coordinate system offset amount is changed during
automatic operation (including during single block stop), the changes will be valid from the
command in the next block or after several subsequent blocks.
2.9 Tool Compensation Amount
49