Mitsubishi Electric 700 Series Training Manual page 179

4. Edit Screens
Operation method (Changing the drawing display position)
(1) Press the menu Display range .
Zoom Zoom
in out
(2) Press the Up , Down ,
menu or cursor movement keys ↑ , ↓ ,
← , → .
(3) Press the INPUT key.
(Note 1) When changing the display range while the 2-plane display mode such as "XY/XZ", the display
range (scale and display position) for the upper and lower areas changes in the same manner.
The operation method is the same as the 1-plane display mode.
The white-framed display range in the upper and lower areas simultaneously move to the
left/right when the Left , Right keys are pressed.
The white-framed display range of either upper or lower areas moves up and down when the
Up , Down keys are pressed.
Which frame to be moved up/down can be changed with the page key.
(Note 2) The set displayed position will be held even after the power is turned OFF and ON again.
Up Down Left
Left , Right
171
4.3 Program Check (2D)
A white frame indicating the display range appears on the
screen.
The display range input mode is activated, and the following
menu appears.
Right Center-
ing
The cursor ( ) indicating the center of the display and the
frame line move up, down, left and right according to the key
operations.
The display position changes so that the cursor position ( )
is the center of the area.
By changing the display position, the graphic data displayed
on the screen is erased, however, the scale value is not
changed.