Connecting A Quiq Charger To Your Computer - JLG H340AJ Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE

Connecting a QuiQ Charger to your Computer

CHARGER OUTPUTS GREATER THAN 40VDC POSE AN ENERGY AND/OR SHOCK
HAZARD UNDER NORMAL USE. DO NOT ENERGIZE CHARGER WITH AC UNTIL
WIRE ASSEMBLY CLIPS ARE SECURELY CONNECTED TO CHARGER OUTPUT,
AND ALL LEADS ARE SECURED AGAINST MOVEMENT.
ENSURE THE BATTERY LEADS FROM THE USB INTERFACE MODULE ARE PRO-
TECTED FROM SOURCES OF ELECTROSTATIC DISCHARGE THAT MAY DAMAGE
THE UNIT.
To connect a QuiQ charger to your computer:
NOTE: QuiQ Programmer CT must be installed on your computer
before you connect a QuiQ charger.
1. Disconnect AC power from the QuiQ charger.
2. Disconnect the QuiQ charger from all batteries.
3. Connect the Wire Assembly red clip to the charger posi-
tive wire (red).
4. Connect the Wire Assembly black clip to the charger
negative wire (black).
3-68
5. Connect the Wire Assembly to the QuiQ USB Interface
Module.
6. Connect the USB cable upstream end to an open USB
port on your PC.
7. Connect the USB cable downstream end to the QuiQ
USB Interface Module.
3121634