Platform; Support Removal - JLG H340AJ Service And Maintenance Manual

SECTION 4 - BOOM & PLATFORM

4.2 PLATFORM

Support Removal

Figure 4-1. Location of Components Platform Support
1. Disconnect electrical cables from control console.
2. Tag and disconnect the hydraulic lines from the rotator.
Use suitable container to retain any residual hydraulic
fluid. Cap hydraulic lines and ports.
3. Remove the bolts securing the platform to the platform
support, then remove the platform.
4. Using a suitable lifting device, support the platform
support.
NOTE: The platform support weighs approximately 77 lbs. (35 kg).
4-2
5. Remove the bolts and washers securing the support to
the rotator.
6. Using a suitable brass drift and hammer, remove the
rotator shaft, then remove the support from the rotator.
3121634