Table of Contents
Advertisement
Save Complete
Printer Will Now
Reboot...
If there is not enough space on the SD to save the entire flash image, you will be prompted with the
following message.
NOT ENOUGH
SPACE ON SD
Delete SD File
This is a fatal error and requires user intervention. Cycle power on the printer, when prompted to save the
QCMC select <CANCEL> to skip. The printer will boot online and allow access to the SD file menus
located under the Advanced User menu. Delete unnecessary SD files then try the QCMC Save operation
again.
Copying the QCMC "Snapshot" Image to a Second
Printer
Always power off the printer before removing or inserting the QCMC. Place the QCMC into the second
printer's memory slot. Upon power up, the printer software detects the presence of a QCMC and a check
of the QCMC will be performed to determine if there is already a saved flash image from this QCMC on
the printer. If no, the following message will display:
QCMC DETECTED
Copy to Printer?
Yes...Press <ENTER>
No...Press <CANCEL>
NOTE: This message will appear every time at power-up until the QCMC settings are copied to the
printer.
If the <CANCEL> key is pressed, the printer will reboot into normal operation and not copy any
information to the printer. On subsequent power-ups the Copy message above will display again if the
QCMC remains installed in the printer.
NOTE: If the QCMC remains installed in the printer, the MAC address onboard will be used in place of
the resident MAC address to the printer's LAN/WAN interface card.
When the <ENTER> key is pressed, the printer will not go online immediately, but will copy the
contents of the QCMC to the printer's flash, creating a clone of the original printer. Before the copy
process is allowed to continue, checks of the printer configuration will be made. If either of the checks
308
Advertisement
Table of Contents
