Table of Contents
Advertisement
Table 24 LCD Message Troubleshooting Table (H-Series)
Displayed Message
ILL NVM VALUE 5
ILL NVM VALUE 6
ILL NVM VALUE 7
INITIALIZING...
INTAKE FAN CHECK
INTERRUPT UNUSED
VECTOR 00
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM
INTO FLASH
NEW SPX DETECTED
PRESS ENTER
282
Can User
Explanation
Correct?
Yes
Illegal value was stored into
the Novram module.
Yes
This message indicates the
printer is beginning its
initialization process.
Yes
Sensors cannot detect
current in fan circuit.
No
The controller board
receives an interrupt it does
not understand. The problem
can be created by electrical
noise, by a software
problem, or by a hardware
problem.
No
Status message: the new
emulation program is loading
into printer RAM. XX%
indicates how much of the
program has loaded.
No
The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory.
No
The printer detects an SPX
installed at the debug port
and the SPX is valid for the
printer.
Solution
1.
Cycle power. Run the print
job again. If the message
appears, load the latest
emulation software.
2.
Cycle power. Run the print
job again. If the message
appears again, record the
exact display message,
follow the instructions on
page 248, Diagnostics for
EXX, BAD NVM, or ILL
NVM Errors, and contact
your authorized service
1
representative.
No action is required.
Cycle power. If the message
appears, press CLEAR. If the
message does not clear, contact
your authorized service
1
representative.
Cycle power. If this message
occurred once and never again,
you can ignore it. If the message
reappears or appears
consistently, contact your
authorized service
1
representative.
No action is required.
No action is required.
Contact your authorized service
1
representative.
Advertisement
Table of Contents
