Printronix P8000 Plus Series Administrator's Manual page 130

Autowrap
This option defines the printer action when print data is received past the forms width setting.
•
With LF+CR (factory default). Performs an automatic carriage return and line feed when data is
received past the forms width.
•
With CR. Performs an automatic carriage return (without line feed) when data is received past the
forms width.
•
Disable. Discards any data past the forms width.
Overstrike
This option enables you to print bold characters.
•
Enable (factory default). Turns on bold print. When enabled, overstrike printing slows down the
printer.
•
Disable. Turns off bold print.
Define LF Code
•
LF = LF (factory default). Does not perform an automatic carriage return when a line feed command
is received. The next print position will be the current print position of the next line.
•
LF = CR + LF. Forces an automatic carriage return with each line feed command received. The next
print position is print position 1 of the next line.
Printer Select
•
Disable (factory default). Ignores the ASCII DC1 and DC3 control codes.
•
Enable. Disables the printer when a DC1 control code is received, and enables the printer when a
DC3 control code is received.
Alt. Set 80-9F
•
Control Code (factory default). Interprets data in the range of hex 80 through hex 9F as a control
code.
•
Printable. Prints data in the range of hex 80 through hex 9F.
Character Set
Specifies a character set as shown in the Serial Matrix Character Set Menu on page 131. To use one of
these sets, choose the desired group heading (such as European Sets) and press ENTER. Then choose
the desired set within that group (such as Roman 8) and press ENTER. Both the group and the desired
set will be starred to indicate your selection. Character sets are shown in detail in the Character Sets
Reference Manual.
ESC d command
•
Even dot plot (factory default). Interprets the ESC d command as even dot plot.
•
Double high. Interprets the ESC d Command as double high. Select this option for backward
compatibility.
130