Printronix P8000 Plus Series Administrator's Manual page 114

Font Attributes
Typeface (ASCII)
NOTE: Not all firmware types have the entire list of typefaces.
•
Data Processing (factory default). A general purpose font printing out at 120 dpi horizontally and 72
dpi vertically. The width of the font will vary with each cpi. For Indian Language firmware, the Indian
character sets must be selected for Indian characters to print.
•
NLQ. A high quality font printing at 180 dpi horizontally and 96 dpi vertically. This font has serifs and
the width of the font varies with the cpi. For Indian Language firmware, the Indian character sets must
be selected for Indian characters to print.
•
OCR-A / OCR-B. Optical character recognition fonts printing at 120 dpi horizontally and 144 dpi
vertically. Both fonts print only at 10 cpi.
•
High Speed. A draft quality font printing at 120 dpi horizontally and 48 dpi vertically. The width of the
font varies with the cpi.
•
NLQ Sans Serif. A high quality font printing at 180 dpi horizontally and 96 dpi vertically. This font
prints without serifs. The width of the font varies with the cpi.
•
High Speed 100. A draft quality font printing at 100 dpi horizontally and 48 dpi vertically. When
chosen from the front panel, it defaults to 10 cpi. The cpi can then be varied, but the width will not
change.
•
NLQ 200. This NLQ font prints at 200 dpi horizontally and 96 vertically. When chosen from the front
panel, it defaults to 12 cpi. The cpi can then be varied, but the width will not change.
•
DP 200. This Data Processing font prints at 200 dpi horizontally and 72 vertically. When chosen from
the front panel, it defaults to 12 cpi. The cpi can then be varied, but the width will not change.
•
High Speed 64. This font prints at 120 dpi horizontally and 64 vertically. When chosen from the front
panel, it defaults to 10 cpi. The cpi can then be varied, but the width will not change.
•
BARCODE 145. This Data Processing font prints at 145 dpi horizontally and 72 vertically. When
chosen from the front panel, it defaults to 12 cpi. The cpi can then be varied, but the width will not
change.
•
BARCODE 160. This Data Processing font prints at 160 dpi horizontally and 72 vertically. When
chosen from the front panel, it defaults to 13 cpi. The cpi can then be varied, but the width will not
change.
Typeface (Arabic Language)
NOTE: These Arabic typefaces appear at the end of the list above for the Arabic Language firmware
only. They are only used when the Arabic Analyzer is enabled.
•
NLQ Naskhi bold
•
NLQ Kofi
•
NLQ Kofi bold
•
NLQ Hadeeth
•
NLQ Req'a
•
NLQ Haydar
•
NLQ Asri
114