Table of Contents
Advertisement
•
Disable (factory default). The active emulation parameters are loaded when the reset command is
executed.
•
Power-Up Config. The power-up configuration is loaded when the reset command is executed.
•
Current Config. The currently selected configuration is loaded when the reset command is executed.
•
Factory Config. The factory installed configuration is loaded when the reset command is executed.
Set Substitution
When this option is activated, the character set overlay in RAM is activated. This can also be
accomplished through a host command of SFCC RX. In either case, a flag is set indicating that the
substitution table is active. If the power-up configuration has Ld Set at Pwrup and Set Substitution both
enabled, the character set overlay is automatically activated at power-up or during a soft reset. See the
LinePrinter Plus Programmer's Reference Manual for more information.
Barcode x-offset
•
Disable (factory default)
•
Enable. Allows text to print next to a barcode when xxxx and yyyy are not set to the origin.
Barcode Height
•
Disable (factory default)
•
Enable. If Barcode x-offset is enabled, the barcode height follows P5000 legacy barcode behavior.
Error Handling (H-Series)
This command determines the way illegal DBCS characters are processed:
•
Normal (factory default). Will ignore illegal DBCS characters.
•
As Space. Will insert two space characters (0X20, 0X20) when the data stream contains the illegal
DBCS character.
•
As Square. Will insert a black square (0xAIBD) when the data stream contains the illegal DBCS
character. This is applicable for the Hanzi Big5 build only.
120
Advertisement
Table of Contents
