Table of Contents
Advertisement
NTSC
This green LED indicates that the 525 line SDI signal is present on the SDI IN connector
and there is NTSC video available at the COMP output BNC connectors.
PAL
This green LED indicates that the 625 line SDI signal is present on the SDI IN connector
and there is PAL video available at the COMP output BNC connectors.
NO SIGNAL This red LED indicates that there is no valid SDI signal is present on the SDI IN
connector.
PSU 1, 2 These LED's will be On to indicate that their corresponding power supply is functioning
normally. On units fitted with a single power supply the PSU 2 LED will be Off all the time.
2.6.
SPECIFICATIONS
The Multivert has ten identical channels. The number of inputs and outputs shown are per channel.
2.6.1. Serial Video Inputs
Standard:
Connector:
Equalization:
Return Loss:
Impedance:
2.6.2. Serial Video Outputs
Standards:
Connectors:
Signal Level:
DC Offset:
Rise and Fall Time: 200ps nominal
Overshoot:
Return Loss:
Wide Band Jitter:
2.6.3. Analog Video Outputs
Number of Outputs: 2 Per Channel
Standards:
Connectors:
Signal Level:
DC Offset:
Return Loss:
Impedance:
Figure 8: Close up of Front Panel
SMPTE 259M-C – 525 and 625 component.
BNC per IEC 169-8
Automatic to 300m @ 270 Mb/s with Belden 8281 or equivalent cable
> 15 dB up to 540 Mb/s
75 ohm
Serial component 270 Mb/s (SMPTE 259M-C)
1 BNC per IEC 169-8
800mV nominal
0V ±0.5V
<10% of amplitude
> 15 dB
< 0.15 UI
Analog composite NTSC if input is 525i/59.94 video
Analog composite PAL if input is 625i/50
2 BNC per IEC 169-8
1 V p-p nominal, internally adjustable
0V ±0.1V
> 45 dB up to 6 MHz
75 ohm
Model 3410 Multivert Manual
Revision 1.2
Page 7
Advertisement
Table of Contents
